12.6 Events (v2.5)

Owned by Copy Page Tree
Last updated: May 28, 2020 by Georg Deisting
1 min read

This is a simplified summary of the just:connect user interface. For detailed information about every single element of the user interface refer to chapter 13. just:connect Advanced Setup.

This tab allows you to configure hardware based 3rd party devices, which can be controlled using the Event Layer of the just:live and just:play user interface.

 

1. Event device and configuration area: Select the device protocol and the method (serial or network) you would like to use to connect to the external device.

The following protocols are available:


2. Add Button: Adds the configured Event Device to the list of Event Devices on the right.

3. Currently active event devices: Lists all currently active Event Devices.


Depending on the device you can use a serial connection, a MOXA Ethernet to serial device or an Ethernet based connection to control the device.

Removing an Event Device

  1. Make sure you have selected the proper Channel in the Channel List.
  2. Go to the Events tab.
  3. Select the Event Device in the Currently active event devices list on the right.
  4. Press the backspace key.
  5. Accept the warning dialog to remove the Event Device. This cannot be undone.


→ Use the sidebar to navigate.