In the Just Control Configuration panel, you can access and change all available settings for Devices and Channels. Once a Device connection has been established, the Just Control Configuration panel will remember and save all Devices connected in the “Devices & Channels” list.

Access the Configuration Panel

Use the menu command “Channels → Show Configuration Panel” to open the Just Control Configuration panel.

Alternatively, you can use the “Connections” tab in the Inspector. Clicking the “Configure” button or double-clicking a Device in the list opens the Just Control Configuration window.

If there are no Devices, press the “Add Connection” button first, this also opens the Just Control Configuration window.

Open

Just Control Configuration Panel Overview

The Just Control Configuration panel consists of two different areas:

Open

Devices & Channels (1)

Displays all currently connected Devices and the corresponding Channels.

Settings Area (2)

Depending on the current selection in the “Devices & Channels” list, this area displays all available options for the currently selected Device or Channel. Furthermore, different tabs at the top contain all the required configuration options.

Adding a New Device

Unlock the panel by entering the administrator password. Press the “Plus ” button ("Add Device") below the “Devices & Channels” list to add a new Device. Enter the IP Address of the machine running the just:in linux engine. The default port (“5000”) is usually correct unless your network administrator specified a different one. Press the “Add” button to establish the connection.

Device Wizard

When connecting a Device for the first time, a Device Wizard will help you with the basic configuration and settings. First, select either “Configure device with the detected physical inputs”, if you want to set up a just:in linux engine for use with SDI or HDMI inputs, or choose “Configure device for streaming inputs (e.g. NDI®, SRT) with the following format” if you would like to set up a just:in linux engine with streaming input(s) only.

If you select Configure device with the detected physical inputs, press the “Scan” button to detect all available video input cards. Select the Video Mode (“SDI (AJA)”) and the Video Format (“1080i25”) and move on to the Device and Channel Name. Define a Default Storage Path (Destination Preset) and filter and select Capture Presets from the list below. Press the “Configure” button to finish the Device Wizard setup process.

Add existing Devices

You can connect already existing and configured Devices in the same way as new Devices. Use the Plus (“+”) button and enter the IP address of the just:in linux server, and the connection will be established automatically.

Remove Devices

A connected Device can be removed from the “Devices & Channels” list by using the Minus (“-”) button.

Device Status

There are various Device statuses available:

• Green light indicator: A device is connected successfully and the just:in engine application is running

• Red light indicator: A Device is not connected (e.g. wrong IP address) or the engine is not running.

Change Device Name

The Device name can only be changed when there is no Channel enabled. To do so, double-click the Device Name (next to the Device Status), adjust the “Name”, and press the “Enter” key to confirm.

Connections Tab and Configuration Panel Correlation

As mentioned above, the Just Control Configuration panel is the central place, where all settings can be managed. The Just Control Configuration panel is responsible for the Channels which are available to the Just Control user/operator within the Just Control User Interface (“Connection” tab in the Inspector) as well. Only enabled Channels are available in the Just Control User Interface within the “Connections” tab.

In the screenshot above, four Channels (Channel 1-4) of the Device “stewie” are enabled. All of these four Channels can be connected to the Multi viewer (in the screenshot, only “Channel1” and “Channel2” are connected).