6.16 Building GPI/Router Control Events (v2.0)

It is possible that your system administrator has already prepared events. If this is not the case or if you need other events, please contact your system administrator or follow the instructions below.

Click on the Event tab of the Library.

Gliffy Diagram is only supported by the cloud editor

Because Forge macros arent supported by the legacy editor, you'll need to convert this content to the cloud editor to display this macro properly. Find out more about converting to the cloud editor

Adding a crosspoint

Click on the "+" in the lower right corner of the Events tab, to open the event control window.

Gliffy Diagram is only supported by the cloud editor

Because Forge macros arent supported by the legacy editor, you'll need to convert this content to the cloud editor to display this macro properly. Find out more about converting to the cloud editor

Configure and create the crosspoint

Name the Preset: The preset name given here will appear in the Event tab in the library of just:live later. Change the name here once you saved a preset by clicking the Create Preset button, otherwise you will overwrite the previously saved preset.

Add events: A preset can consist of one or more events. For example, a preset can switch several outputs on a video router, or send one or more GPI events, or even combine video router and GPI events in a single preset.

Available Events: This is the list of available events which are depending on the selected just:out preferences file.

Create preset: When you have added all events to the preset, click the Create Preset button to create the preset which will automatically appear in the Events tab in the library of just:live/just:play. You can then use the preset(s).

Repeat: Repeat steps 1 to 4 for each preset you need. When you are finished click the Done button.

Gliffy Diagram is only supported by the cloud editor

Because Forge macros arent supported by the legacy editor, you'll need to convert this content to the cloud editor to display this macro properly. Find out more about converting to the cloud editor

Deleting a crosspoint

ctrl-click on the crosspoint you would like to delete and select Reveal in Finder.
Move the crosspoint to the Trash to remove it also from the Event tab.