3. live:cut Installation

Owned by Thomas Staiger
Last updated: Jun 08, 2016Version comment
3 min read

Before you begin make sure that you have OS X 10.10.5/10.11 or higher installed as well as the current drivers from → Blackmagic Design.

live:cut version 1.4.1 will ONLY run on OS X 10.10.5/10.11 or higher!

 

 

For NEW installations of live:cut:

  1. → Download live:cut from our helpdesk. It is part of the just:in installer disk image.
  2. Open the just:in installer disk image.
  3. Drop the "LiveCut" icon onto the "Applications" folder below.
  4. Navigate to the folder /Applications/LiveCut and double-click on Just In Engine QuickTime to initialize the software packages. You will be asked to update your system and to allow access to system resources such as Apple Calendar. Confirm all of them by clicking OK and by entering your credentials when asked.

Optional: Install the ToolsOnAir GPI Box driver to connect to a vision mixer or switcher other than a Blackmagic Design ATEM. You can find the driver on the just:in installer disk image in the folder Additional Content/Service USB Drivers. 

The next step is to configure and activate your channel(s).


For UPGRADE installations of live:cut:

In case of a previous activation of any version prior to v.1.4.1 you will need a new activation code. Please → contact ToolsOnAir to receive an updated activation code under software maintenance.

  1. → Download live:cut from our helpdesk. It is part of the just:in installer disk image.
  2. Open the just:in installer disk image.
  3. Drop the "LiveCut" icon onto the "Applications" folder below and confirm that you want to replace the existing files.
  4. Navigate to the folder /Applications/LiveCut and double-click on Just In Engine QuickTime to initialize the software packages. You will be asked to update your system and to allow access to system resources such as Apple Calendar. Confirm all of them by clicking OK and by entering your credentials when asked.

Optional: Install the ToolsOnAir GPI Box driver to connect to a vision mixer or switcher other than a Blackmagic Design ATEM. You can find the driver on the just:in installer disk image in the folder Additional Content/Service USB Drivers. 

Your capture presets and channel(s) configuration will be kept. If you upgrade from a previous version of live:cut, you will need to recreate the destination presets in the Just In Configuration preference panel in order to reflect the new multiple destinations structure.

Once the upgrade setup is done, restart Just In Engine QuickTime, launch live:cut, enter the activation code and connect to the desired channels.

 

The live:cut installation process installs following components:

  • LiveCut: /Applications/LiveCut/LiveCut.app
  • Just In Engine QuickTime: /Applications/LiveCut/Just In Engine QuickTime.app

 

In case of a previous activation of any live:cut version prior to v1.4.1, you will need to enter a new activation code. Please → contact ToolsOnAir to receive your updated activation code under software maintenance.

 


→ Use the sidebar to navigate.