/
Preferences: Engine Tab (just:in v2.0)

Preferences: Engine Tab (just:in v2.0)

Accessing the Preferences

  1. Go to the menu Just In Engine.
  2. Select Preferences.
  3. The just:in Engine Preferences will show up as seen below.

Engine Tab


  • Engine framerate: select the desired framerate.
  • Continue writing into same container after signal loss:
    • Enabled: keeps the container opened during a signal loss and makes just:in resume the Recording into the same container as soon as the signal is available again. This only works for QuickTime containers.
    • Disabled: upon signal loss just:in will stop recording, close the container and resume Recording into a new file as soon as the signal is available again. This works with QuickTime and MXF containers in Crash Mode only.
  • Use fallback frame count: the amount of frames (max. 200) that will be buffered before switching to the fallback destination. A fallback destination has to be defined in the Presets tab for this feature to work.
  • Use external LTC timecode: select an external timecode source. Not supported for Blackmagic devices.
  • Preview Network Communication Interface: select the network interface which will be used as communication interface.
  • Preview Network Clock Port: if port 9999 is free on your network this setting can be kept.



Related content

Engine Configuration (just:in Engine Mac v3.5)
Engine Configuration (just:in Engine Mac v3.5)
More like this
6. Engine Configuration (just:in Engine Mac v3.0)
6. Engine Configuration (just:in Engine Mac v3.0)
More like this
Crash Recording (just:in v2.0)
Crash Recording (just:in v2.0)
More like this
1. Crash Recording (just:in v3.0)
1. Crash Recording (just:in v3.0)
More like this
[JIM] Crash Mode v.6.5
[JIM] Crash Mode v.6.5
More like this
Crash Mode (just:in v3.5)
Crash Mode (just:in v3.5)
More like this

→ Use the sidebar to navigate.