13.10 Changing a Layer Name (v.2025.x)
You must unlock the Configuration panel first to perform any changes.
Before proceeding, you must stop the Channel by deactivating the checkbox. Stopping the channel will also stop the Just Out Primary engine output, unless there is a Redundant engine available.
Changing the name of a Layer will change the name of the Layer in the user interface. Use less than 8 characters for just:play and less than 4 characters for the just:live user interface. Otherwise, the name will be shortened.
Stop the desired Channel by deactivating the checkbox in front of it. Stopping a Channel will also stop the Just Out engine and therefore the final output.
Select the Channel in the “Devices & Channels” list.
Click on the “Layers & Engines” tab.
Click on a Layer name.
Enter a new name and press the “Enter” key afterward.
Activate the checkbox in front of the Channel to start it again and to take over the changes you made.
Close the configuration window and drag the Channel from the “Connections” tab to the “Multi viewer” area.
