[JIM] Channel Ordering v.6.1

The Channel ordering in live:cut depends on which Channels were selected for the live:cut project in the first place. For instance, when you have four Channels selected in Just Control, then you will have four Channels in your live:cut project. Channel ordering goes from top left to bottom right, as shown in the following screenshot.

Open

Open

In case you have four Channels connected in Just Control but you are only using two Channels (in this example, Channel 1 and Channel 4) for live:cut, the Channel ordering will change accordingly. Please refer to the screenshots below (Channel 2 and Channel 4 are connected but not active in live:cut mode).

If you are working with a different set of channels for different scenes, and you want that CAM 4 always sticks as CH 4 in live:cut, then you can accomplish that with different live:cut templates and Channel mappings. This means that you will have to create a live:cut Template for each scene. So you will end up having a live:cut project for a three-camera scene, a five-camera scene, and so on.