[JIM] AJA Ki Pro v.5.5

General

AJA Ki Pro Event Devices can be used to start and stop Recordings on given AJA Ki Pro recorders. Furthermore, other supported operations such as the “Play” command are supported as well. A detailed workflow description is available here.

Devices

Select the Device from the “Device & protocol” list, enter the IP address of the AJA Ki Pro and press the “Add…” button to create the Device.

Open

Then a new window appears, where further configuration is required.

Open

Select the desired AJA Ki Pro device from the Preset list and press the Plus (“+”) button next to it.

Then select the “Command” parameter, and you will see the supported values for the AJA Ki Pro in the value selection box.

Use the “Test” button to verify a working connection.

Further configuration will be done within the Recording Event itself. Please see below:

Presets

Define a name for the Preset, select the AJA Ki Pro Event Device, and press “Add”.

Finally, choose the desired command, that should be triggered later within the Inspector of Just Control. Once done, press the “Finish” button and the Event will be visible within the Presets list.