[JIM] Blackmagic Design HyperDeck v.5.5

Owned by Christian Schabasser
Last updated: Jul 20, 2023 by Manuel Grund
2 min read

General

The BMD HyperDeck Event Device can be used to trigger recordings on an external Blackmagic Design HyperDeck Device. Furthermore, it is possible to set the file name as well, so that both the just:in mac and the Blackmagic Design HyperDeck recording have the same file naming. Please see the BMD HyperDeck Workflow Description for more details.

Devices

Select the TCP Event Device, set a “Timeout/Delay” value and enter the IP address of the Blackmagic Design HyperDeck device and press the “Add…” button.

Once a new window pops up, select “Blackmagic HyperDeck” from the presets list and press the “+” button. With this Event Device Configuration it is possible to create “Play”, “Record” and “Stop” Event Presets.

If the recorded files on the Blackmagic Design HyperDeck should have a matching file naming logic as for the just:in mac channels, then select “Blackmagic HyperDeck Named Record” from the presets list.

Please note that with the “Blackmagic HyperDeck Named Record” preset option, recordings can only be started. To stop on ongoing record, a standard BMD HyperDeck Event Device is required. Fore more details, please see the the BMD HyperDeck Workflow Description.

Press the “Ok” button to save the Event Device upon completion.

Presets

When the Event Device is completed, a new Event Preset can be created. Add a new Preset, set a name, select the BMD HyperDeck device and press the “Add” button. Then set the value to “Record” and save the Event Preset by pressing the “Finish” button.

Once that is done, this Event Preset is available within the Channel Inspector.

 

→ Use the sidebar to navigate.