Table of Contents

Preface

In Batch Mode a channel records a Batch List of predefined In- and Outpoints from a VTR Device. Batch Mode requires a valid VTR Device (RS422) connection.

Starting a Recording

1. Make sure to have at least one valid Naming,- Capture- and Destination-Preset already created in the Configuration Panel. And at last one Channel connected to the Channel Viewer Area.
   
   
   
2. Open the Inspector and switch the Channel into Batch Mode.
   
   
   

3. Select a Naming Preset and define a clip name for the first Batch Entry. Then also check if the correct Timecode Source is selected.
   

   Please make sure that a valid Capture- and Destination-Preset is selected.

4. Define your Batch List by entering an Inpoint, Outpoint and/or Duration. Press the Log button for each entry. To add further entries press the Reset button and repeat this step.
   
   
   
5. Hover over the Channel View and press the Record button.
6. You can see the status of the current ongoing Batch Log in the Inspector.
   
   
   
7. When the Batch List has been recorded successfully, you will see an appropriate Log in the Logs & Error List.
   
   
   
8. In case the Batch Recording has been canceled or has been aborted you will see an appropriate Error in the same Log & Error List.
9. To add new entries to a new Batch List you need to clear the existing list by pressing the Clear All button above the VTR Controls.