To change Channel Settings deactivate the desired Channel(s) by unchecking the corresponding checkbox(es).
Deactivating a Channel will make it unavailable in connected just:in User Interfaces.
Basic Channel Settings
- Channel Name: Edit the Channel name by double clicking on the name within the Channel List.
- Input Source: Select the Input Source here.
- Video Mode: Select a Video Mode here. The modes depend on the Engine's Framerate and the Video Device.
- Chunk Length: Set the Chunk Length here. The maximum is 12:00:00:00.
- Port: Edit the Channel Port here.
- Signal Loss: By default a Channel stops recording when there is a signal loss during recording. By enabling Continue Writing the Channel will continue recording into the same container in case there is a signal loss during recording. The gap during the signal loss will be filled with black frames automatically. The Channel might get out of AV sync in case of a a signal loss that occurs on a running Channel/Engine.
(Re-)Enabling a Channel
After changing the settings of a Channel you need to enable it again by clicking on the corresponding checkbox. You can only activate a Channels with valid Video Modes.
