General
The TCP Device enables the possibility to perform actions towards the Blackmagic Design Videohub.
Devices
Select the Device from the “Device & protocol” list, enter the IP address of the Blackmagic Design Videohub and press the “Add…” button to create the Device.
Then a new window appears, where further configuration is required.
First, choose Blackmagic Design Videohub as Preset and press the Plus (“+”) button next to it.
If the Blackmagic Design Videohub can be reached, everything should be good, but to make sure, use the “Test” button to check the connection.
As can be seen, the response is ok and this step can be finished by pressing the “Ok” button.
Further configuration will be done within the Recording Event itself. Please see below.
Presets
tbd