Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Current »

Accessing the Preferences

  1. Go to the menu Just In Engine.
  2. Select Preferences.
  3. The just:in Engine Preferences will show up as seen below.

Engine Tab


  • Engine framerate: select the desired framerate.
  • Continue writing into same container after signal loss:
    • Enabled: keeps the container opened during a signal loss and makes just:in resume the Recording into the same container as soon as the signal is available again. This only works for QuickTime containers.
    • Disabled: upon signal loss just:in will stop recording, close the container and resume Recording into a new file as soon as the signal is available again. This works with QuickTime and MXF containers in Crash Mode only.
  • Use fallback frame count: the amount of frames (max. 200) that will be buffered before switching to the fallback destination. A fallback destination has to be defined in the Presets tab for this feature to work.
  • Use external LTC timecode: select an external timecode source. Not supported for Blackmagic devices.
  • Preview Network Communication Interface: select the network interface which will be used as communication interface.
  • Preview Network Clock Port: if port 9999 is free on your network this setting can be kept.



  • No labels

→ Use the sidebar to navigate.