Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 3 Current »

Preface

You can record SDI, HDMI signals, or NDI® streams on the fly in Crash Mode (i.e. you start and stop each Capture/Recording process manually).

Start a Recording

Make sure to have a valid Capture- and Destination Preset configured and that at least one Channel is connected successfully. Select a Channel, open the Inspector, and make sure that the Channel is in Crash Mode.

JIML2025_crashrecording.png

Now hover over the Channel Viewer and the “Record” button will show up. Press this button to start the Recording.

JIML2025_crashrecording2.png

You can use the keyboard shortcut “Command-R” to Start/Stop a recording.

An ongoing Recording is indicated by a red border around the inner area of the Channel Viewer and a “RECORDING” message overlay.

Stop a Recording

Click the “Record” button again to stop recording. The recorded clip will be available at the appropriate path in the file system (defined in the Destination Preset).

  • No labels

→ Use the sidebar to navigate.