Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 10 Next »

To be able to use a Channel configured in the Just Control Configuration window, the Channel must be Started and assigned to a Viewer of the Multi Viewer Interface.

What is a Channel?

A Channel is a virtual representation of a single output signal. Depending on the number of Devices, you may configure one or multiple Channels.

Before connecting to a Channel using Just Control, it is mandatory that the  channel is running and configured correctly. Refer to the Playout v3.0 Administrator Manuel for more information.

Channel not started:

In case a Chanel is not started, it can not be seen under the Connections Tab of the Just Control User Interface or in one of the windows of the Multi Viewer.

  • The checkbox in front of the Channel is not activated and therefore the Channel is not shown under the Connections tab of the Inspector.

Channel started but not assigned to a Viewer:

Once a Chanel is started, it can be seen under the Connections Tab of the Just Control User Interface and is ready to be assigned to one of the windows of the Multi Viewer.

  • The checkbox in front of the Channel is activated and therefore the Channel is shown under the Connections tab of the Inspector.

  • There is a red dot in front of the Channel under the Connections tab of the Inspector which indicates, that the channel is not assigned to a Viewer.

Channel started and is assigned to a Viewer:

A Chanel is fully functional once it has been assigned to a window of the Multi Viewer Interface.

  • The checkbox in front of the Channel is activated and therefore the Channel is shown under the Connections tab of the Inspector.

  • There is a green dot in front of the Channel under the Connections tab of the Inspector which indicates, that the channel is assigned to a Viewer.

  • The Channel is shown in a window of the Multi Viewer Interface and the kind of Channel is shown at the top of the window.

How to assign a Channel to a Viewer:

A Channel can be assigned to any unused Viewer of the Multi Viewer Interface via Drag and Drop or double click.

  • Drag and Drop: Grab a channel (which has a red dot in front) from the Connections tab of the Inspector to an unused Viewer of the Multi User Interface

  • Double Click: Click on an unused Viewer in the Multi Viewer Interface so that it gets selected and double click the channel (with a red dot in front of it) in the Connections tab.

Every time a Channel has been deactivated in the Just Control Configuration window, it must be assigned to a viewer again.

  • No labels