Changing Channel Settings (Inspector)
You are now ready to proceed with your first recording. Select the appropriate capture and destination presets, then press the Record button. You will be recording in Crash mode.
Once you have connected a channel to the interface, you can see the incoming video stream, as well as the audio meters. Furthermore you can open the inspector by pressing on the settings button, which will appear when you move with your mouse inside the preview or you can simply select the channel and press cmd + i.
In the inspector your can set the file name, timecode source, metadata and the capture- and destination presets. To start a recording you have to select at least one capture- and destination preset.
The recording button appears as soon as the channel settings are ok.
Please make sure you have valid channel settings configured, unless the recoding button will not appear.
To start a recording, simply press on the record button or use cmd + r. When a currently recording channel is selected, the channel border will flash between red and cyan. You can stop a recording by using cmd + r or by just pressing the recording button again.
Multiselection
With v2.5 it is possible to change settings of two or more channels at the same time. Just select the channels and then press the settings button or hit cmd + i to open the inspector. Then make the changes and these are applied to all selected channels.
Please beware that when you select channels of different engines, the naming of the presets must be identical.