Table of Contents

Preface

In Batch Mode a channel records a Batch List of predefined In- and Outpoints from a VTR Device. Batch Mode requires a valid VTR Device connection.

Starting a Batch Recording

1. Make sure to have at least one valid Capture Preset and one valid Destination Preset in just:in Engine.
   
   
   
2. Make sure you are connected to a Channel in just:in.
   
   
   
3. Select Batch Mode in the desired Channel View. VTR Controls can be found in the Inspector.
   
   
   
4. Select a Naming Preset and define a clip name.
   
   
   
5. Select a Capture Preset and a Destination Preset.
   
   
   
6. Define your Batch List by entering an Inpoint, Outpoint and/or Duration. Press the Log button for each entry.
   
   Click Reset to clear a Inpoint/Outpoint before adding the sequence to the batch list.
   
   
7. If you wish you may modify the other settings.
   
   
8. Now hover over the Channel View. Next to the Inspector button there's a Record button. Press the this button to start the Batch Recording (shortcut: command +R).
   
   
9. You can see the status of the current ongoing Log the table in the Inspector.
   
   
   
10. just:in informs you when the Batch List has been recorded successfully,
    
    
    or in case the Batch Recording has been canceled or has been aborted.
    
    
    
11. To be able to add new entries to a new batch list you need to clear the existing list by pressing the Clear table button.