...
Some broadcast stations must be able to add Audio- and Graphics-based emergency alerts to their broadcast signal using an emergency alert system. The DASDEC Digital Alert System can receive such a signal and pass it over to just:connect which uses just:out to add the Audio and Graphics information to the output signal.
Configuring the EAS Option in just:connect
- Make sure EAS is activated for the desired Channel. You can also use Demo mode to test EAS.
- Select the Channel you would like to configure to communicate with the EAS device.
- Click on the Advanced tab in the configuration area.
- Click the Configure button to open the EAS configuration window.
...
Info |
---|
|
DASDEC Settings
Note |
---|
The setup shown here is a guideline on how the configuration can be done. Depending on the DASDEC device and the firmware installed the user interface of the device and therefore also the configuration itself can be different. |
Encoder Settings
Setup Settings