Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

...

...

...

Table of Contents

Table of Contents

Preface

In Batch Mode a channel records a Batch List of predefined In- and Outpoints from a VTR Device. Batch Mode requires a valid VTR Device connection.

Starting a Recording

  1. Make sure to have at least one valid Capture Preset and one valid Destination Preset in just:in Engine.


  2. Make sure you are connected to a Channel in just:in.


  3. Select Batch Mode in the desired Channel View. VTR Controls can be found in the Inspector.


  4. Select a Naming Preset and define a clip name.


  5. Select a Capture Preset and a Destination Preset.


  6. Define your Batch List by entering an Inpoint, Outpoint and/or Duration. Press the Log button for each entry. To add further entries press the Reset button and repeat this step.


  7. Adjust the other settings accordingly to your needs.
  8. Hover over the Channel View and press the Record button (shortcut: command +R).
  9. You can see the status of the current ongoing Batch Log in the Inspector.


  10. just:in informs you when the Batch List has been recorded successfully.


  11. In case the Batch Recording has been canceled or has been aborted you will get a warning.


  12. To be able to add new entries to a new Batch List you need to clear the existing list by pressing the Clear table button.