...
Send “GPI Out” Trigger with this Device type.
| Note |
|---|
Please beware note that an external hardware device (Service USB Plus) is required for this Event Device. |
...
Select the Device from the “Device & protocol” list and press the “Add…” button to create the Event Device. Further configuration will be done within the Recording Event itself. Please see below.:
...
Presets
Open the “Events” tab and switch to the “Presets” sub-tab, then . Then use the “Add Preset” button to create a new Event Preset.
...
Set a name for the Event Preset, select “Service USB GPI OUT” and press “Add”.
...
Then Now, you can configure the actual Event can be configured. Please beware note that you can add multiple GPI trigger here, simply triggers. Simply press the “Add” button again and configure the new Event. Once everything is set up, press the “Finish” button and the Event will be visible within the Event Presets list, and therefore it will be available within the Inspector of Just Control as well.
...
Double-click on the Preset to modify it again, select the Preset and hit the “Enter”- key to adjust the Preset name.