Destination Presets contain settings about the recording locations of the Recordings, Metadata files, SCC sidecar - files, or XMP Marker files. Before you can start Recordings within Just Control, you have need to create one or multiple Destination Presets. After defining Presets Once defined, you can quickly access them in Just Control. This speeds up accelerates the Recording process and helps to keep things organized.

Overview

Open the “Just Control Configuration PanelConfiguration” panel, select a Device and switch to the “Destination Presets” Tab tab.

...

1. Destination Preset List: shows all available “Destination PresetsPresets” for the selected Device. Use the buttons below to add and remove “Destination PresetsPresets”.

2. Destination Preset Configuration Options: create and set new container types here, by using the Add and Minus button Delete buttons below.

   • Container:

     • Main Container: Sets the main recording path for a recording.

     • Metadata: Sets the path for writing the metadata sidecar file.

     • SCC Captions: Set the path for writing the SCC sidecar file.

     • MCC Captions: Set the path for writing the MCC sidecar file.

   • Path: Select the Container Path here.

   • Type:

     • Main Path: Main recording location.

     • Fallback: Fallback recording location (just:in mac switches to the fallback path automatically, in case the main recording location gets to too slow or does not respond at all). Please beware note that this Container Type is only available for the Main Container.

Add a Destination Preset

In the “Device & Channel ListChannel Lis”t select a Device. Click on the “Destination PresetsPresets” tab. Below  Underneath the “Destination Preset ListList” press the Plus (“+”) button to add a “Destination PresetPreset”.

...

A new window appears, where you can add the “Destination Preset NameName”. Press the “Create” button to go back to the “Destination PresetPreset” options. Configure the “Destination PresetPreset” according to your needs. It will be saved automatically after all attributes are have been defined. You may change the settings of a Destination Preset “Destination Preset” at any time.

Edit an existing Destination Preset

Select an existing “Destination PresetPreset” and change the options on the right side. The changes will be saved automatically.

Remove a Destination Preset

Select an existing “Destination PresetPreset” and use the Minus (“-”) Button below the Destination Preset button underneath the “Destination Preset” list to remove the selected “Destination PresetPreset”.