Overview
This page chapter covers the Channel Viewer in every detail. The Channel Viewer looks the same for each Input type (SDI, HDMI, and NDI®5) of the Just In Engine application.
...
Timecode Modes
You can choose between the following Timecode Modes:
Off
Dual Timecode
Small
Medium
Large
Timecode + Name
Off
Hides Completely hides the Timecode Display for this particular Channel Viewer completely. Note that you could display the Timecode at in the bottom bar as well.
...
Dual Timecode
Displays the current Timecode in the top-left corner and the Elapsed Time during Recording in the top-right corner.
...
Small
Displays a Small Timecode Displayoverlay.
...
Medium
Displays a Medium Timecode Displayoverlay.
...
Large
Displays a Large Timecode Displayoverlay.
...
Timecode + Name
Displays the current Timecode in the top-left corner and the Channel Name in the top-right corner.
...
| Info |
|---|
Click on the current Timecode Display to switch to the Elapsed Recording Time (during Recording, ; otherwise it will display 00:00:00:00). |
...
IP and Port
Displays the IP - Address and Port of this Channel.
...
Displays the currently defined filename.
...
Timecode
Displays the current currently selected Timecode.
...
Channel Status Overlay
The Channel Viewer Status Overlay either shows that the Channel is in Recording mode or that there is a problem, which needs the attention of the user/operator.
No Overlay
If there is no overlay, the Channel is configured properly and is currently in idle mode.
...
The recording overlay as well as the red recording borders indicates indicate that the Channel is currently in recording mode.
...
There was a problem during the recording. Consult the Error “Error” section in the Settings “Settings” tab of the Inspector or take have a look in the Channel log.
...
A connection could not be established, or a connection has not yet been established.
...
There was a problem during the last Recording or during the time where when the Channel was in Idle Mode. Consult the Error “Error” section in the Settings “Settings” tab of the Inspector or take have a look at the channel log.
...
No Signal
The Channel has no or an invalid signal.
...