| Table of Contents |
|---|
Overview
The just:in linux appliance ships preinstalled with following components:
...
just:in linux engine (tme) and just:connect (tjc) start automatically after the OS boot process. If they are configured properly, both services can communicate with just:control immediately.
Deployment
The just:in linux appliance comes preinstalled with a specific CentOS 7.x release:
7.4 (1708)
7.5 (1804)
7.6 (1810)
7.7 (1908)
7.8 (2003)
7.9 (2009)
If you require a specific CentOS version, when ordering a just:in linux appliance, please contact us.
User and Password
The system can be accessed with following credentials via ssh.
...
| Note |
|---|
Please beware that there is no Linux GUI pre-installed on the just:in linux appliance and it is not recommended to install one. All set up processes can be done via the command line. |
Network Settings
By default em1 is set to DHCP and em2 gets configured with a static IP-Address. The IPMI port gets a static IP-Address as well.
...
| Code Block |
|---|
sudo ipmicfg -m |
IPMI
As mentioned above, the server can also be accessed via the IPMI port. Open a browser and enter the IPMI IP-Address (Username: ADMIN, Password: will be provided upon request).
...
| Note |
|---|
European and Worldwide customers: please use the above mentioned Username and Password combination. US customers: a dedicated IPMI password needs to be provided. You will get this from either your US/Canada distributor or from ToolsOnAir via separate mail. |
Blackmagic Firmware Updater (Legacy)
| Warning |
|---|
Only update the Blackmagic driver if you have issues with the system. Please contact your local reseller or the ToolsOnAir Support System before. |
...
| Code Block |
|---|
BlackmagicFirmwareUpdater update [device] |
just:connect Configuration File & Logs
Config File
just:connect stores all Channel related information (settings, presets…) in following configuration file:
...
| Info |
|---|
Please beware that you can save and restore the JustConnect.txt file within the UI (config panel - System Tab) as well. |
Logs
just:connect saves log files for each recording channel independently. There is log file for each just:connect start and the just:connect log files are located here:
...
| Code Block | ||
|---|---|---|
| ||
/var/log/tme |
Restarting the just:in linux engine and just:connect service
With following commands the just:in linux engine and/or the just:connect service can be restarted:
...
| Code Block |
|---|
sudo tme restart |
Automatic Server Restarts
If the server should be rebooted automatically, a cronjob has to be activated. This can be done with the following command as root:
...
| Note |
|---|
Please contact your local ToolsOnAir reseller or the ToolsOnAir Support Team before. |
Server Restart with Channels in Schedule Mode
If you have to restart the server, please make sure that you are following these steps, when you are working with Channels in Schedule Mode:
Stop the Scheduled Recording for all Channels running in Schedule Mode
Switch all Channels to Crash Mode
Restart the server
Switch the Channels back to Schedule Mode
Software Updates
Please contact your local ToolsOnAir reseller or ToolsOnAir directly, if you want to update your just:in linux appliance.