...
| Info |
|---|
The proxy preview in the On Air window shows a compressed image with a reduced frame rate. In addition, the Preview can stop for a moment if the communication is interrupted, even when the real output is fine. This means that the Preview cannot is not meant to replace a broadcast monitor for the final check of the master playout. |
...
| Info |
|---|
The actual setup and configuration of the Settings is done by your system administrator. For a full overview of the Settings, refer to Chapter https://toolsonair.atlassian.net/wiki/spaces/TST/pages/3580594691#Just-Control-Preferences. |
To open the “PreferencesSettings”, go to the menu “Just Control → Preferences”→ Settings”.
Playout
...
Show names for all items in the Timeline: Activating this option will show the names of all items in the Timeline as an overlay. If this option is deactivated, you can still move the mouse pointer above an item in the Timeline to see its name.
Show tooltips in the Library: Deactivate this option to disable tooltips in the Library while moving the mouse pointer over entries. This option is enabled by default.
Poster Frames Cache: This defines the folder where poster frames will be saved. By default, the poster frames are saved in the folder “Poster Frames” inside the “Documents” folder of the current user. This option is enabled by default. Disable it to suppress the creation of new poster frames in the Workbench of just:play.
Default Video In-Point: This option is disabled by default. Enable it to enter a timecode value. Once enabled, the in-point of Videos that are dragged from the Library into a Playlist will be set to the specified value (assuming that the Video contains timecode). This is useful if all of your Videos contain a trailer or countdown before the actual video content starts.
...