General
The Using the Blackmagic ATEM Event Device can be used for changing the PGM Output of , you can perform the following tasks on a Blackmagic Design ATEM Live Production Switcher.
...
Devices
Select the Click on the “Add” button to select the “Blackmagic ATEM (Ethernet)” Device from the “Device & protocol” list, enter the IP address of the Blackmagic Design ATEM production switcher, and press the “Add…” button to create the Device. Further configuration will be done within the Recording Event itself. Please see below.
...
refer to the screenshots below:
...
Presets
Set To create a new Preset, define a name for the Preset, select “Blackmagic ATEM” and press “Add”.
...
Now define which Input should be routed to the PGM Out. In addition, you can set the mixer level and, if required, the “auto-transition” option. Other options can be defined when using the selection box on the top right, such as:
...
Once everything is set up, press the “Finish” button and the Event will be visible within the Presets list, and therefore it will be available within the Inspector of Just Control as well.
...