Table of Contents

Preparing a Channel in just:connect

In just:connect, repeat the following steps for each channelChannel you would like to configure.

1. Unlock just:connect for the desired channel Channel and activate the Expert User mode by clicking the respective tab in the upper middle of the just:connect application window.
2. Activate on the Workflows tab.
3. Click on the Standard Workflow button.
4. Under Workflow Communication, activate the Enable on port checkbox.
5. Enter a port which is currently not used on this machine and make sure that the same port is not used for another channel Channel on this machine.
   

Managing Channels in just:next

...

1. Click on the Add Channel button in the upper right of the just:next application window.
   Image Added
   
   
2. Enter a Channel Name. You can use any name but it makes sense to use the same name like defined in just:connect.
3. IP: Enter the IP-Address of the machine running just:connect which hosts the channel Channel you would like to control.
4. Enter the Workflow Communication Port you have previously defined in just:connect.
   Do not use the port of the channel Channel which is shown in the channel Channel view of just:connect.
5. Click the Add Channel button.Image Removed
6. The Channel should now be visible in the Channel list.

Editing a Channel

1. Select a channel Channel in the channels Channels list of just:next.
2. Click on the Edit Channel button.
3. Edit the settings accordingly to your needs. 
4. Click the Edit Channel button to apply your changes.
   

Removing a Channel

1. Select a channel Channel in the channels Channels list of just:next.
2. Click on the Remove Channel(s) button.
3. You will be asked if you really want to remove the selected channelChannel(s).