...
This will open a new window where the following entries/action actions have to be done/performed. First make sure , ensure that the IP address is correct, then choose select “Blackmagic Hyperdeck” from the Preset list and press the “+” Button.
...
The related Blackmagic Hyperdeck parameters will be automatically added to the list. Select the “Command” parameter and pick a value to test the connection to the given Blackmagic Design HyperDeck (next step).
...
Press the “Ok” button below to add the HyperDeck Event Device to the just:in mac Configuration.
...
It is possible to You can double-click to on the newly created Event Device to set a custom Device name as well.
...
Now switch to the “Presets” sub-tab (within the “Events” tab) to create a Start- and Stop-Recording Event Preset for this specific Blackmagic Desin HyperDeck. Use the “Add Preset” button to create a new Event Preset. Set a Preset Name, make sure verify that the correct Event Device is selected, and then use the “Add” button to add the Event Device to the Event Configuration. Afterwards Next, adjust the value parameter of the Preset. In this case, choose “Record”, as this should be the Start Recording preset.
...
Repeat the step above to create another Event Preset to enable the Stop Recording event on that particular Blackmagic Design HyperDeck device (Value The value option should be “Stop”). Yow You now have two available Event Presets.
...
Let’s go back to the Channel Inspector to set up the new Event Presets for a given Channel. Select a Channel and choose select the new Events as Start and Stop Recording Event Presets.
...
Then start the recording process for this Channel and the recording will be automatically started on that specific BMD Blackmagic Design HyperDeck. When stopping the recording with Just Control, the recording process gets will be stopped on the Blackmagic Design HyperDeck as well.
...
This configuration process can be done for each individual Blackmagic Design HyperDeck (Event Devices). Then multiple Event Presets (Start & Stop) have to be created and finally every just:in mac Channel executes these Events to trigger recordings on separate Blackmagic Design HyperDecks.
Setup HyperDeck Named Record (Configuration Panel)
Additionally In addition to the start and stop recording commands, just:in mac can provide the given HyperDecks Blackmagic Design HyperDeck with the file name as well. This makes the workflow even more useful, as the recording of just:in mac and of the BMD Blackmagic Design HyperDeck have the same file name. In order to To set this up, open the Just Control Configuration Panel panel and switch to the Event Presets Tab “Events Presets” tab again. Repeat the steps from above, “TCP” as “Device & protocol” option, timeout “timeout” value, and the dedicated IP address of the Blackmagic Design HyperDeck device. Then press the “Add…” “Add…” button again.
...
Next, choose “Blackmagic “Blackmagic Hyperdeck Named Record” Record” and click the “+” button next to the selection field.
...
Finish this process by using the “Ok” “Ok” button. A new Event Device will be created, which can be renamed again , if that is required.
...
Switch to the Presets Sub sub-Tab tab and add a new Preset Preset to the Configuration. Then enter a preset name, select the new BMD Hyperdeck Named Record Event Device and press “Add”“Add”. Then use the “Finish” “Finish” button to create the new Event Preset.
...
The new Event Preset will be added to the just:in mac Configuration.
...
Record Process HyperDeck Named Record (Channel Inspector)
Let’s switch back to the Just Control main user interface and select the new Event Presets within the Event Events section (Inspector). The Stop Event can be the same as before. Next, start recordingthe Recording.
...
When the recording Recording is stopped, the file name of the just:in mac recording Recording and the file name of the Blackmagic Design HyperDeck recording will be the same.
...