| Table of Contents |
|---|
Preface
You can record SDI, HDMI signals or IP Streams (NDI®5) on the fly in Crash Mode, i.e. you start and stop each Capture/Recording process manually.
Start a Recording
Make sure to have at least one valid Capture- and Destination-Preset configured and that at least one Channel is connected successfully. Select a Channel and open the Inspector and make sure that the Channel is in Crash Mode.
...
You can use the keyboard shortcut “Command + R” to Start/Stop a recording.
...
A Capture ID consists of a Capture Preset and a Destination Preset. Open the Inspector of the desired Channel. At the bottom of the Inspector add further Capture IDs by pressing the Add ("+") button. Select a Capture Preset and Destination Preset for each Capture ID and start the Recording process as described above.
...
You may start multiple Recordings of a single Video source at the same time to the same or to multiple destinations. This feature is limited by the hardware specs of the machine running the Just In Engine application. We strongly recommend to do thorough testing before using this feature in a live environment.
Use the Minus “-” button to delete Capture IDs again.