[JIM] Device v.5.5
- Christian Schabasser
- Manuel Grund
Available I/O Devices are:
Just Control User Interface
Service USB
Blackmagic Design ATEM production switcher
TSL UMD
ToolsOnAir GPI Box
When using the ToolsOnAir GPI Box you need to select “Service USB” as the I/O Device.
Make sure that the Service USB Box is connected via USB to the live:cut machine and that the Service USB driver is installed.
Blackmagic ATEM
Before selecting this I/O device, verify that the Blackmagic Design ATEM software is installed on the machine running live:cut.
Enter the Host IP address of the Blackmagic Design ATEM production switcher and press the “Apply” button. If you're being asked to update the Project Template confirm it.
User Interface
Use this option to use the live:cut User Interface as a "Vision Mixer". In this mode, the active camera can be changed by the following means:
Clicking on the desired Channel.
Using the buttons at the very bottom of the live:cut (Just Control) User Interface.
Using keyboard shortcuts (as described in the corresponding chapter).
TSL UMD
The TSL UMD option enables the possibility to establish the connection to a vision mixer that supports the TSL UMD protocol, such as the Ross Production Switchers. Select the new option within the “Device” Tab and enter the port number, which was configured on the Production Switcher before.
Then press on the “Defaults” button to gather the default configuration options. If needed, change these options accordingly.
Please beware that the Switcher must be configured correctly with the IP Address of the machine running Just Control (live:cut). Otherwise, the application will not receive any information from the vision mixer.
live:cut support TSL UMD version 3.1.