Once the initial setup of Just In Mac Lite is done, the configuration file is saved for the current available/connected video devices (AJA/Blackmagic Design). For instance, a Just In Mac Lite setup could run with an AJA Corvid 88 or Blackmagic Design DeckLink 8K Pro.
But there are situations, where the video hardware gets changed because the current one is broken. This page describes the workflow of such a video hardware change.
Step 1 - Delete config.json file
Quit the Just In Mac Lite application and open the following folder:
/Library/Application Support/ToolsOnAir/Just In
Then search for the “config.json” file. Duplicate this file for backup purposes and then delete the original one.
Step 2 - Change video hardware and install driver
Next, change the video hardware and if necessary, install the most recent AJA/Blackmagic Design driver. Once the system is up and running again, make sure that the new video device can be discovered by the operating system (AJA Control Panel or Blackmagic Design Desktop Video Setup application).
Step 3 - Create new configuration
Now start both the Just In Mac Lite application again. The application detects that there is no current configuration available (see Step 1) and therefore checks for connected video devices. Since we changed the hardware setup and installed a new driver, the Just In Mac Lite application now finds the new/changed video hardware. As a last step, complete the configuration according to your needs.
Please note that all Presets (Naming, Capture, Destination) will be available after completing the steps above.