12.6 Events (v2.5)
This is a simplified summary of the just:connect user interface. For detailed information about every single element of the user interface refer to chapter 13. just:connect Advanced Setup.
This tab allows you to configure hardware based 3rd party devices, which can be controlled using the Event Layer of the just:live and just:play user interface.
1. Event device and configuration area: Select the device protocol and the method (serial or network) you would like to use to connect to the external device.
The following protocols are available:
2. Add Button: Adds the configured Event Device to the list of Event Devices on the right.
3. Currently active event devices: Lists all currently active Event Devices.
Depending on the device you can use a serial connection, a MOXA Ethernet to serial device or an Ethernet based connection to control the device.
Removing an Event Device
- Make sure you have selected the proper Channel in the Channel List.
- Go to the Events tab.
- Select the Event Device in the Currently active event devices list on the right.
- Press the backspace key.
- Accept the warning dialog to remove the Event Device. This cannot be undone.