5.3 NON DSK Based Switch to Live Configuration (v2.0)
The advantage of using the built-in method is, that it is possible to switch between a live signal and the playout of a movie without the need of a video router. In addition it is possible to add graphics to the live signal without the need of a second video device.
Like described above, there are two methods to achieve this and here is how the NON DSK based setup has to be done.
Make sure the right Firmware is loaded (AJA only)Using the AJA Control Panel, the device must be flashed to the 4K mode with 2 inputs and 2 outputs before it can be used.
Activating the 4K mode of an AJA device, the ability to do hardware based Up, Down and Cross conversion as well as the ability to activated the DS Keyer or to play out Fill&Key will be disabled. | |
Select the right switch to live method for your channelOpen the Advanced Output Format settings of just:connect and select one of the available Without DSK-based settings.
| |
Connect a signal and select the input in the Advanced Output Format settings.
Using an AJA, the final output will be shown on SDI 3, using an BMD, all outputs will be active. |
Passing through ClosedCaption data
Make sure to activate the VANC option under the Format tab of the AJA control panel to pass through any CC data which comes with the input signal. Passing through of CC data is only supported using devices from AJA (Kona 4) while using a "Without DSK" or "Disabled" Live SDI input configuration in the channel settings of just:connect.