[JIM] Stop Recording based on Timecode v.5.5

While Recording you can enter a “Stop On Timecode” value, which will be used to stop a Recording on that given Timecode automatically. Start a Recording and open the Inspector. Within the Timecode section, first, enter a valid “Stop on Timecode” value and then enable the “Stop on Timecode” feature.

The Record button will display that the “Stop on Timecode” feature is activated. Note that you cannot stop the recording manually at this point. If you want to do that, disable the “Stop on Timecode” feature beforehand.

→ Use the sidebar to navigate.