Available I/O Devices are:
User Interface
Service USB
Blackmagic Design ATEM
TSL UMD
When using the ToolsOnAir GPI Box you need to select Service USB as the I/O Device.
Make sure that the Service USB Box is connected via USB to the live:cut machine and that the driver is installed. |
Before selecting this I/O device make sure the Blackmagic Design ATEM software is installed on the machine running live:cut. |
Enter the Host IP address of the Blackmagic Design ATEM and press the “Apply” button. If you're being asked to update the Project Template accept it.
Use this option to use the live:cut User Interface as a "Vision Mixer". In this mode the active camera can be changed by following means:
Clicking on the desired Channel.
Using the buttons at the very bottom of the live:cut User Interface.
Using keyboard shortcuts (as described in the corresponding chapter).
The TSL UMD options enables the possibility to establish the connection to a vision mixer that supports the TSL UMD protocol, such as the Ross Production Switchers. Select the new option within the “Device” Tab and enter the port number, which was configured on the Production Switcher before.
Then press on the “Defaults” button to gather the defaults configuration options. If needed, change these options accordingly.
