On the just:in Engine Linux server appliance you can find:
just:in Engine (tme) and just:connect (tjc) start automatically when the OS starts. If they are configured properly they can immediately communicate with a just:in User Interface.
The system can be accessed with following credentials via ssh.
User: justin Password: justin Example: ssh justin@IP-ADDRESS |
By default both network ports are set to DHCP (also the IPMI port is set to DHCP). When connected to the just:in linux server appliance with ssh, the IP addresses can be displayed with one of the following commands:
ip addr or ifconfig -a |
The IP address for the IPMI port gets shown at startup, when there is a monitor connected to the server (VGA port) or the address can be displayed with following command (you will not be asked for a password here):
sudo ipmicfg -m |
As mentioned above, the server can also be accessed via the IPMI port. To do so, simply open a browser and enter the IPMI IP-Address. Access the page with ADMIN:ADMIN.
Only update the Blackmagic driver if you have issues with the system. |
In some situations the Blackmagic video card needs a Firmware update. Verify if the card is working properly with the installed driver version by using the following command:
BlackmagicFirmwareUpdater status |
No Firmware update is required if all inputs display the status ok. If the status is not ok use following command to update the firmware. Restart the system afterwards.
BlackmagicFirmwareUpdater update [device] |
just:connect stores all Channel related information (settings, presets…) in this file:
/var/justconnect/JustConnect.txt |
Delete this file if there is a major problem with the system. After deleting this config file just:connect (tjc) must be restarted and reconnected within the UI.
Please beware that you can also save and restore this JustConnect.txt file within the UI (config panel - System Tab). |
just:connect saves log files. There is log file for each just:connect start and for each channel. It can be found here:
/var/log/justconnect |
The just:in linux engine also saves logs for each channel. These can be found here:
/var/log/tme |
These commands restart just:in Engine Linux and just:connect. They must be executed as root ('sudo').
just:in Engine Linux | sudo systemctl restart tme |
---|---|
just:connect | sudo systemctl restart tjc |
just:in Engine Linux & just:connect | sudo tme restart (this command will delete all existing log files from both, tme and tjc and backups everything to /media/internal_raid/tools/) |
If the server should be rebooted automatically, a cronjob has to be activated. This can be done with the following command as root:
(crontab -l 2>/dev/null; echo "0 2 * * * /usr/bin/tme restart") | sudo crontab - |
This command restarts the server everyday at 2AM.
Please contact your TOA reseller or TOA directly if you want to update your just:in linux appliance.