2. Batch Recording (just:in v3.0)

What is Batch Recording?

Batch Recording records a Batch List of predefined In- and Outpoints from a VTR Device. Batch Recording requires a valid VTR Device connection.

Making a Batch Recording

  1. Make sure to have at least one valid Capture and one valid Destination Preset in just:in Engine.


  2. Make sure you are connected to a Channel in just:in.


  3. Select Batch Mode in the desired Channel View. VTR Controls will appear when the remote functionality is enabled on the VTR, otherwise you will not see any VTR Controls.


  4. Open the Inspector of the desired Channel by clicking on the Sprocket.


  5. If you have not done so, please select a Naming Preset and define a clip name.


  6. If you have not done so, please select a Capture Preset and a Destination Preset.


  7. Define your Batch List by entering an Inpoint, Outpoint and Duration. Press the Log button for each entry.

    Click Reset to clear a Inpoint/Outpoint before adding the sequence to the batch list.

  8. If you wish you may modify the other settings.

  9. Now hover over the Channel View. Next to the Inspector button there's a Record button. Press the this button to start the Batch Recording (shortcut: command +R).

  10. You can see the status of the current ongoing Log the table in the Inspector.


  11. just:in informs you when the Batch List has been recorded successfully,


    or in case the Batch Recording has been canceled or has been aborted.


  12. To be able to add new entries to a new batch list you need to clear the existing list by pressing the Clear table button.

→ Use the sidebar to navigate.