...

1. Open a live:cut Project via the just:in User Interface.
   
   
   
2. Go to the menu Project → Settings and click on the Paths tab. Verify if everything has been configured properly. Refer to the previous chapters if the configuration is incomplete.
   
   
   
3. Click on the Editor tab. Verify if everything has been configured properly. Refer to the previous chapters if the configuration is incomplete.
   
   
   
4. Click on the Device tab. Verify if everything has been configured properly. Refer to the previous chapters if the configuration is incomplete.
   
   
   
5. Close the Project Settings by pressing the OK button.

2. Start Recording

...

As soon as the Recording has been started you may switch between Cameras (= Channels) by using one of the following methods. The availability of the methods depends on your device configuration.

...

4. Stop Recording

Press the Recording button Record button again and accept to dialog to stop the recording.

...

1. After the Recording stops live:cut creates a Multi-Camera XML out of the EDL and saves it to the folder which is defined in the Project Settings. This XML can then be imported into the Video Editor. To automate this process you may enable the Open after Export function in the Project menu.
2. Open the Video Editor (in this case we are using Final Cut Pro X) and select Import XML.
3. Import the XML file.
   
   
   
4. You can now stark working on your multicam timeline sequence.
   

...