Versions Compared

Version Old Version 4 New Version Current
Changes made by

Georg Deisting

Manuel Grund

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Note

You must unlock the Just Control Configuration window and stop the channel(s) first to be able to make perform any changes.

Each Channel has a certain output format (frame size, frame rate, and bit depth) in which the engines connected to this Channel are "rendering" the final output.

...

  1. Stop the desired Channel by deactivating the checkbox in front of it. Stopping a Channel will also stop the Just Out engine and therefore the final output.

  2. Select the Channel in the “Devices & Channels Channels” list.

  3. Click on the Format “Format” tab.

  4. Select the desired output format in the “Output FormatFormat” drop-down menu.

  5. Activate the checkbox in front of the Channel to start it again and to take over the changes you just made.

  6. Close the configuration window Just Control Configuration panel and drag the Channel from the “Connections” tab to the Multi - viewer area.