...
Minimal CentOS installation (CentOS 7.x)
Video card driver (AJA)
just:in linux engine (TOA Media Engine = tme)
just:connect (TOA just:connect = tjc)
just:in linux engine (tme) and just:connect (tjc) start automatically after the OS boot process. If they are configured properly, both services can communicate with the macOS based Just Control applicationimmediately.
...
If you require a specific CentOS version, when ordering a just:in linux appliance, please contact us.
...
As mentioned above, the server can also be accessed via the IPMI port. Open a browser and enter the IPMI IP-Address (Username: ADMIN, Password: will be provided upon request).
...
Blackmagic Firmware Updater
| Warning |
|---|
Only update the Blackmagic Design driver if you have issues with the system. Please contact your local reseller or the ToolsOnAir Support System before. |
...
just:connect Configuration File & Logs
Config File
just:connect (tjc) stores all Channel related information (channel settings, presets, etc.) in following configuration file:
...
Delete this file if there is a major problem with the system. After deleting the config file, tme and just:connect (tjc) must be restarted.
| Code Block |
|---|
sudo tme restart |
| Info |
|---|
Please beware that you can save and restore the JustConnect.txt file within the UI (config panel - System Tab - Configurations) as well. |
Logs
just:connect (“tjc”) saves log files for each recording channel independently. There is log file for each just:connect start and the just:connect log files are located at:
| Code Block | ||
|---|---|---|
| ||
/var/log/justconnect |
The just:in linux engine (“tme”“tme”) saves logs files for each channel as well. These log files get saved at:
...
With following commands the just:in linux engine and/or the just:connect service can be restarted:
just:in linux engine
| Code Block |
|---|
sudo systemctl restart tme |
just:connect
| Code Block |
|---|
sudo systemctl restart tjc |
Both just:in linux engine and just:connect:
| Code Block |
|---|
sudo tme restart |
| Info |
|---|
This command will delete all existing log files from both, just:in linux engine and just:connect and saves all logs to the internal RAID at “/media/internal_raid/tools/” automatically. |
The tme status script
In order to get an overview about the server and the current running processes, there is a “tme” status script available, which provides information like system information, running processes, internal RAID state, AJA driver, etc. Run following command to execute the tme status script:
...
If the services should be rebooted automatically, a cronjob has to be activated. This can be done with the following command as root:
...
This command restarts the services (“tme” and “tjc”) everyday at 2AM2 A.M.
| Note |
|---|
Please contact your local ToolsOnAir reseller or the ToolsOnAir Support Team before. |
...
In order to get the correct new time applied to the recording engine, the services (“tme” and “tjc”“tme” and “tjc”) have to be restarted. Afterwards restart the Just Control application as well. Please beware that by restarting the recording services, possible ongoing recording will be stopped. Therefore we recommend to stop recording manually before restarting the recording services.
...
Please contact your local ToolsOnAir reseller or ToolsOnAir directly, if you want to update your just:in linux appliance.