Introduction
Once the just:in linux appliance is wired (power, network, video signals) and set up (network) correctly, it is possible to connect to the just:in linux server and to start with the initial setup of just:in. In order to achieve that, following steps are required:
Check the IP-Address, which will be used for the communication between the just:in linux server and the User Interface (just:control).
Install just:control on a macOS based system, which has access to the just:in linux appliance (via the network).
Establish the connection to the just:in linux appliance with just:control.
IP-Address
Normally the just:in linux appliance has multiple network connections. One gets used for communication purposes, such as interacting with just:control and another one will be used for the storage system connection. In order to be able to access the just:in linux server with just:control, the IP-Address of the communication port is required (normally em1 gets used for that).
Please contact your network administrator or your local ToolsOnAir reseller or the ToolsOnAir team directly, if you do not know the current IP-Address of the just:in linux server.
Installation (just:control)
| Info |
|---|
The just:control application can be found on the internal just:in linux RAID or within the Download Area of the ToolsOnAir support system. |
...
| Info |
|---|
If there is no just:control disk image on the internal RAID, please create a ticket in the ToolsOnAir Support System. |
Usage (just:control)
Go to the macOS Applications folder and open just:control.Press the Login button to move on.
...