...

...

What is Crash Recording?

Crash Recording records Video signals on the fly.

Making a Crash Recording

1. Make sure to have at least one valid Capture and one valid Destination Preset in just:in Engine.
   
2. Make sure you are connected to a Channel in just:in.
   
3. Select Crash Mode in the desired Channel View.
   
4. Open the Inspector of the desired Channel.
   
5. It is required to select a Naming ConventionPreset, a Capture Preset and a Destination Preset. If you wish you may modify the other settings.
   
6. Now hover over the Channel View. Next to the Inspector button there's a Record button. Press the this button to start the Recording (shortcut: command +R).
   Note: if the Record button does not show up, verify your Capture and Destination Presets in just:in Engine.
   
7. The border of the recording Channel will continuously change colors from turquoise to red, indicating that there is a Recording in progress.
   
8. To stop the Recording, click the Record button again. The recorded clip will be available in the filesystem.
   
   
   

...