What is Batch Recording?
Batch Recording records a Batch List of predefined In- and Outpoints from a VTR Device. Batch Recording requires a valid VTR Device connection.
Making a Batch Recording
- Make sure to have at least one valid Capture and one valid Destination Preset in just:in Engine.
- Make sure you are connected to a Channel in just:in.
- Select Batch Mode in the desired Channel View. VTR Controls will appear when the remote functionality is enabled on the VTR, otherwise you will not see any VTR Controls.
- Open the Inspector of the desired Channel.
- Select a Naming Preset and define a clip name.
- Select a Capture Preset and a Destination Preset.
- Define your Batch List by entering an Inpoint, Outpoint and Duration. Press the Log button for each entry.
- If you wish you may modify the other settings.
- Now hover over the Channel View. Next to the Inspector button there's a Record button. Press the this button to start the Batch Recording (shortcut: command +R).
- You can see the status of the current ongoing Log the table in the Inspector.
- just:in informs you when the Batch List has been recorded successfully.
- Clear the Batch list to To be able to add new entries to a new batch list you need to clear it by pressing the Clear table button.
