...

Starting with version 5.5, both just:in mac and just:in linux solutions support Event Presets. Event Presets can be used to trigger Channel-related actions such as the Start, when performing a Split and/or to Stop a Recording. This page describes the configuration steps and workflow of AJA Ki Pro Event Presets that can be used to trigger start and stop recording actions on given AJA Ki Pros at the same time as the actual just:in mac Channel(s) start recording. In this case, the dedicated AJA Ki Pros will be used as backup recorder units.

...

Setup (Configuration Panel)

Your starting point is, as always, the Just Control Configuration panel. Open the panel, select the just:in mac Device on the left side, and switch to the “Events” tab. Then verify that the “Devices” sub-tab is selected. Then use the Add Button to add a new Event Device. Next, choose the “HTTP” option from the “Device & protocol” list and adjust the “Timeout/Delay” option. Enter the IP address of the given AJA Ki Pro to the IP address field and finally click on the “Add…” button below.

...

This will open a new window where the following entries/actions have to be done/performed. First, ensure that the IP address is correct, then select “AJA Ki Pro” from the Preset list and press the “+” Button next to it.

...

The related AJA KiPro parameters will be automatically added to the list. Select the “Command” parameter and pick a value to test the connection to the given AJA Ki Pro (next step).

...

Next, use the “Test” button below to verify if the connection is working and commands can be sent to the chosen AJA Ki Pro. If there is a Green light next to the “Test” button, everything is OK. This can be verified via the Ki Pro Web interface as well (IP address of the AJA Ki Pro).

...

If that is working correctly (Response “Status: 200”), press the “Ok” button below to add the “Ki Pro Event Device” to the just:in mac Configuration.

...

Repeat the steps above to create another Event Preset to enable the Stop Recording event on that particular AJA Ki Pro device (The value option should be “Stop”). You now have two available Event Presets.

...

Record Process (Channel Inspector)

Let’s go back to the Channel Inspector to set up the new Event Presets for a given Channel. Select a Channel and select the new Events as Start and Stop Recording Event Presets.

...