...

Starting with version 5.5, both just:in mac and just:in linux solutions support Event Presets. Event Presets can be used to trigger Channel-related actions such as the Start, when performing a Split and/or to Stop a Recording. This page describes the configuration steps and workflow of AJA Ki Pro Event Presets that can be used to trigger start and stop recording actions on given AJA Ki Pros at the same time as the actual just:in mac Channel(s) start recording. In this case, the dedicated AJA Ki Pros will be used as backup recorder units.

Setup (Configuration Panel)

Your starting point is, as always, the Just Control Configuration panel. Open the panel, select the just:in mac Device on the left side, and switch to the “Events” tab. Then verify that the “Devices” sub-tab is selected. Then use the Add Button to add a new Event Device. Next, choose the “HTTP” option from the “Device & protocol” list and adjust the “Timeout/Delay” option. Enter the IP address of the given AJA Ki Pro to the IP address field and finally click on the “Add…” button below.

...

Repeat the steps above to create another Event Preset to enable the Stop Recording event on that particular AJA Ki Pro device (The value option should be “Stop”). You now have two available Event Presets.

...

Record Process (Channel Inspector)

Let’s go back to the Channel Inspector to set up the new Event Presets for a given Channel. Select a Channel and select the new Events as Start and Stop Recording Event Presets.

...