Versions Compared

Old Version 1

changes.mady.by.user Georg Deisting

Saved on

compared with

New Version Current

changes.mady.by.user Manuel Grund

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Note

  • Before proceeding, you must stop the channel Channel by deactivating the checkboxin front of it. Stopping the channel will also stop the Just Out MAIN Primary engine and therefore the final output in case output, unless there is no redundant a Redundant engine available.

  • You must unlock the Just Control Configuration window panel first to make perform any changes.

Just Control provides two areas with channel Channel settings, the Just Control Configuration window panel and the Settings tab of the MultiViewer Multi viewer interface.

  1. Just Control Configuration window panel - provides more basic settings and the channel has . The Channel needs to be stopped before a setting can be changed.

  2. Just Control MultiViewer Settings Tab - provides additional settings and the settings there can be changed while the channel is running.

...