Page Comparison

...

1. Go to the Applications folder and open the just:in Application.
2. The just:in main window appears.
   Image RemovedImage Added
   
   
3. Select a grid layout for the channel viewer. This can be reverted at any time later.
   Image Removed 
   Then the actual just:in user interface opens You may change the grid layout later on.
   Image Added 
   
   
4. The channel viewer shows up with the selected grid layout.
   Image Removed
   Open the Inspector on Image Added
   
   
5. On the right side of the user interface, open the Inspector and switch to the Connections -Tab. There press tab.
   Press the Add Connection -Button button to open the Configuration Window window.
   Image RemovedImage Added
   
   
6. Unlock the Panel panel by clicking on the cock symbol lock icon on the bottom left side.
   Image Removed
   Authorise yourself to unlock the Configuration Panel.
   Image RemovedImage Added
   
   
7. Enter the administrator credentials and press the OK button.
   Image Added
   
   
8. Press on the Plus-Button plus button at the bottom of the Devices & Channels list.
   Image RemovedImage Added
   
   
9. Add the IP-Address of your just:in linux server and press the Add-Button button to establish a connection to the server (Port is by default 5000).
   Image RemovedImage Added
   
   
10. The the Configuration Wizard appears, which is helping with the basic configuration steps.
    Image RemovedImage Added
    
    
11. Change settings accordingly hereConfigure the settings to your needs. Please check with your reseller or directly with us, which video hardware is installed, and select your preferred SDI format.
    Then select at least one preconfigured Capture Preset and finish the configuration by pressing the Configure button.
    Image Removed
    
12. Then you can see the engine/device settings and the channel settings.
    Image Removed
    Image Removed
13. There Image Added
    
    
14. The Engine/Device settings should show up.
    Image Added
    
    
15. Clicking on the disclosure triangle next to the Engine's name shows the channels of the Engine. There is no need no change anything here. You can now switch back to the just:in interface and the configuration panel can be closed. Drag&Drop the channels from the Connections-Tab to the viewer area and the channels will be connected to the user interface.
    Image Removed
    Image Added
    
    
16. Close the configuration window.
    Drag and drop the desired Channel(s) from the Connections tab to the Channel Viewer area.
    Alternatively you may also drop the previously configured Device to the Channel Viewer area. All available Channels will then be connected automatically (as long as there are sufficient Channel Viewers.
    Image Added
    
    
17. Once the channels are connected you can check the appropriate settings.
    Image Removed
    Then a recording can be started Image Added
    
    
18. You may then start recording for one or all channels.
    Image RemovedImage Added
    
    

The Getting Started ends here. For further information please refer to the other pages in the user manuals.