Table of Contents
| Table of Contents |
|---|
...
Preface
You can record Video signals on the fly in Crash Mode, i.e. you start and stop each Capture process manually.
Starting a Recording
- Make sure to have at least one valid Capture- and one valid Destination Preset in just:in Engine.
- Make sure you are connected to a Channel in just:in and select Crash Mode in the desired Channel View.
- Click on the Inspector button in the top right corner of the application to open the Inspector of the desired Channel.
It is required to select a Naming Preset, a Capture Preset and a Destination Preset. If you wish you may also adjust the other settings.
Info - Only Capture Presets which match the incoming Video signal will be shown here.
- If you did create a Naming-, Capture- or Destination Preset in just:in Engine while being connected to a Channel in the just:in User Interface you need to select " - " in the appropriate drop down menu to refresh the list of Presets.
Now hover over the Channel View and the Record button will be visible. Press this button to start the Recording (shortcut: command + R).
Info If the Record button does not show up verify the Capture- and Destination Presets in just:in Engine and make sure you have selected both in the Inspector.
- There will be a red border around the inner area of the Channel View, indicating an ongoing Recording.
...