Page Comparison

...

This figure shows all elements of the Channel Preview, it may look different on your system.

Image RemovedImage Added

1. Timecode: displays the Timecode depending on the selected Timecode mode (see below).
2. Channel Preview Border: Turquoise border: when  when you click on a Channel Preview it gets a turquoise border which means it's selected. You may select multiple Channel Previews by holding the commandkey. This is useful if you want to change the Capture settings of multiple Channels at once.
3. Red border: indicates that a Recording is in progress on the particular Channel.
4. Red/Turquoise border: the Channel is selected and a Recording is in progress on the particular Channel.
5. Record Button (command + R): this button shows up as soon as you hover over a Channel. Press this button to start the Recording on the particular Channel.
   • Please note that this button only shows up after selecting a valid Capture and Destination Preset in the Inspector. Refer to the just:in Engine configuration chapter for further details on Presets.
   • If the Record button disappears frequently: lower the resolution and/or framerate in the just:in Engine Channel Preview Options.
6. Inspector Button (command + I): this button shows up as soon as you hover over a Channel. Press this button to open the Inspector of the particular Channel.
   • If multiple Channels are selected, the changes made in the Inspector are valid for all selected Channels.
7. Audio Bars: shows Audio levels.Audio Bars: shows Audio levels.
8. Info/Warning display: If there is a problem with the settings of a channel, or if there was a problem during recording, there will be a info line here (see examples below).
   Image AddedImage AddedImage Added
9. Channel Info: click to switch between Channel Name, IP-Address & Port or Name of the current Recording.
10. Timecode Mode: click to select the Timecode Mode (see below).
11. Recording Mode: click to select the Recording Mode (see below).
12. Channel BufferUpper Bar:  displays the currently buffered frames (if any) of the particular Channel. As long as the Channel Buffer is lower than 50, there is no need to worryin the upper bar the capture and destination-preset will be displayed. If you have more than one Capture-ID selected, "Multiple" will be displayed there.
    
    

...