...
| Info |
|---|
The NDI® source can be selected within the Channel Inspector. Please note that both the Just In Engine and the Just Control application require access to the NDI Network. Also, please be aware that the NDI Test Pattern application from the free NDI Tools is not supported as a source. |
...
Close container, write to new: Recording to the current file will be stopped and as soon as there is a valid signal again the recording will start into a new file.
Close container and stop: Recording will be stopped when the Channel detects a signal loss.
Dropped Frames Strategy (NEW in v.6.5):
Duplicate last valid frame: In case of a dropped frame, the channel adds a duplicate of the last valid frame available.
Add black frame: This option adds black frames for every occurring dropped frame.
...
Add/Remove an NDI® Channel
You can add or remove NDI® NDI Channels at any time. Open the Just Control Configuration panel and select one of the connected just:in mac devices. Then use the “Plus” button to add an NDI® NDI Channel.
Once the new Channel is added, you can adjust the settings and enable it so that you can use it within Just Control. To delete a Channel, select the Channel within the “Devices & Channel” list and press the “Minus 
” button.
| Info |
|---|
Please note, that NDI® NDI Channels can be removed from a Device as well, again. |
| Note |
|---|
Channels can be removed only, if they get disabled/stopped before. |