...
Depending on the current selection in the “Devices & Channels” list, this area displays all available options for the currently selected Device or Channel. Furthermore, there are different tabs at the top that contain all the required configuration options.
...
Unlock the panel by entering the administrator password. Press the “Plus 
” button ("Add Device") below the “Devices & Channels” list to add a new Device. Enter the “IP Address” of the machine running the Just In Engine application. The default port (5000“5000”) is usually correct unless your network administrator specified a different one (when you are running the engine locally, the IP -Address address is already entered). Press the “Add” button to establish the connection.
...
When connecting a Device for the first time, a Device Wizard willhelp you with the basic configuration and settings. First, select either “Configure device with the detected physical inputs”, if you want to set up a Just In Engine for use with SDI or HDMI inputs, or choose “Configure device for streaming inputs (e.g. NDI®5NDI®) with the following format”, if you would like to set up a Just In Engine with streaming input(s) only.
| Info |
|---|
Please note, that you can add NDI®5 NDI® inputs at any time, independent of the Device Wizard process. |
...
You can connect already existing and configured Devices in the same way as new Devices. Use the “Plus” (“+”) button and enter the IP -Addressaddress of the machine running the Just In Engine application, and the connection will be established automatically.
...
There are various Device statuses available:
🟢 Green light indicator: a A Device is connected successfully and the Just In Engine application is running
🔴 Red light indicator: a Device is not connected (e.g. wrong IP Addressaddress) or the engine is not running.
...
The Device name can only be changed when there is no Channel enabled. To do so, double-click the Device Name (next to the Device Status), adjust the Name“Name”, and press the “Enter” key to confirm.
...
In the screenshot above, four Channels (AJA_1, AJA_2, NDI_1, and NDI_2) of the Device “TOA_M1_Demo” are enabled. All of these four Channels can be connected to the multi-Multi viewer (in the screenshot, only “AJA_1” and “AJA_2” are connected).
Please note, that connected Channels get disconnected automatically, when the Channel gets disabled within the Just Control Configuration panel.